OSHA 30 Hour Construction Industry Outreach Training
The OSHA 30 Hour Construction Industry Outreach Training course is a comprehensive safety program designed for anyone involved in the construction industry. Specifically devised for safety directors, foremen, and field supervisors; the program provides complete information on OSHA compliance issues.
OSHA recommends Outreach Training Programs as an orientation to occupational safety and health for workers covered by OSHA 29 CFR 1926.
This course has been approved and accepted by OSHA for online distribution and includes a 75 page Study Guide to assist you through your online learning experience, as well as, ensure you are ready to take the final exam to receive your OSHA DOL Card.
Construction workers must receive additional training, when required by OSHA standards, on specific hazards of the job (your employer must provide this additional training).
Course Learning Objectives:
- Recognize the aspects of 1926 Subpart C (General Safety and Health Provisions)
- Locate OSHA Standards references applicable to specific hazardous conditions and practices (Introduction to OSHA Standards)
- Implement preventative measures for accidents in their workplace (Subpart D- Occupational health and Environmental Controls)
- Describe types of personal protective equipment (PPE), and the requirements for use in OSHA standards (Subpart E- Personal Protective Equipment)
- Understand the requirements for fire protection in the workplace (Subpart F- Fire Protection and Prevention)
- Identify types of rigging equipment used to protect employees (Subpart H- Rigging; Subpart N- Cranes and Rigging)
- Identify the critical health and safety hazards of welding and cutting in the construction industry (Subpart J- Welding and Cutting)
- Identify common electrical hazards and related OSHA standards (Subpart K- Electrical Standards)
- Understand the importance of scaffolding for workers in elevated workplaces (Subpart L- Scaffolding)
- Implement measures for protecting workers and equipment from dangerous falls (Subpart M- Fall Protection)
- Recognize the hazards associated with working in or around excavation sites (Subpart P- Excavations)
- Understand the safety requirements necessary to protect workers around concrete and masonry jobs (Subpart Q- Concrete and Masonry)
- Identify the precautions and hazards to protect workers using explosives or blasting agents (Subpart T- Demolition)
- Protect workers who perform jobs on or around stairways or ladders at worksites (Subpart X - Stairways and Ladders)
- List and describe the hazards and prevalence of confined spaces
These courses includes individual module quizzes that require a score of 70 to proceed forward in the course. The final exam additionally, requires a minimum score of 70 to receive a certificate of completion. The final exam may be taken three times, if necessary.
Once you enroll in the OSHA 30 Hour Construction Outreach Training course you will have 6 months to successfully complete the course. If you do not complete the course in 6 months you will not receive a certificate for course completion.
If you require a temporary printable certificate, it will be made available immediately upon successful completion of course. Passing participants will also receive an OSHA 30 Hour Construction Industry Outreach DOL course completion card within 4-6 weeks.
Please Note: The OSHA 30 Hour Construction Industry Outreach Training course does not have any pre-requisites; however, the OSHA 30 Hour Construction Industry Outreach training course or an equivalent of 30 hours of prior safety and health training plus 5 years of construction safety and health experience is a prerequisite to take a OSHA 500 Trainer Course.